Normal sampling mode does not need the external power supply (supplied by USB port). You can also download data from logger while the logger is still logging. If the logger is logging in fast sampling mode (sampling interval is below 5 seconds for Site-Log, iLog Strain Gauge and 1 second for iLog single channel loggers)…
All Site-Log / iLog data loggers come with 4 mega-byte on-board flash memory. The following table provides relationship between number of enabled channels, sampling interval and the maximum time span of logging: Sampling Interval Enabled Channel Logging Capacity 1 minute 1 3.98 years 1 minute 2 727 days 1 minute 8 181 days 10 seconds…
This depends on the environments the loggers work with and the tolerant standards of the applications. Usually, re-calibration is needed every couple of years.
For a thermocouple data logger, you need to buy the thermocouple sensor/probes. For a external thermistor data logger, you need to buy the thermistor probes. All data loggers need SiteView software to download the data and configure the logger for new logging session. If you want to communicate with the logger via Ethernet or MODEM…
There is no way to turn off the logger. If your purpose is to save the power of the battery you can set the sampling interval to 12 hours.
All data loggers were calibrated before they are shipped out to the customer. So far, We only provide voltage, current, thermistor and thermocouple calibration services.
The on-board LED will turn red when it samples if reading of any associated channel is over the alarm thresholds. You can use SiteView to change the alarm thresholds or enable/disable the alarm notification of any channel.
Please refer to : http://microedgeinstruments.com/meifaq/?p=234
Install driver and software: Install SiteView: Follow the screen instructions to install SiteView software. Refer to Quick Start for the detailed installation. Plug the data logger to the USB port of the computer to finish the USB driver installation. Launch SiteView: Double click SiteView shortcut on the desktop. In the pop-up dialog input the valid…
